16 C.F.R. § 305.15 : Commercial Practices — FEDERAL TRADE COMMISSION — REGULATIONS UNDER SPECIFIC ACTS OF CONGRESS — ENERGY AND WATER USE LABELING FOR CONSUMER PRODUCTS UNDER THE ENERGY POLICY AND CONSERVATION ACT ("ENERGY LABELING RULE") —TESTING — Label content for clothes washers

(a) Label content.
(1) Headlines and texts, as illustrated in the prototype and sample labels in appendix L to this part, are standard for all labels.
(2) Name of manufacturer or private labeler shall, in the case of a corporation, be deemed to be satisfied only by the actual corporate name, which may be preceded or followed by the name of the particular division of the corporation. In the case of an individual, partnership, or association, the name under which the business is conducted shall be used. Inclusion of the name of the manufacturer or private labeler is optional at the discretion of the manufacturer or private labeler.
(3) Model number(s) will be the designation given by the manufacturer or private labeler.
(4) Capacity or size is that determined in accordance with this part.
(5) Estimated annual operating costs are as determined in accordance with this part. Labels must disclose estimated annual operating cost for both electricity and natural gas as illustrated in the sample labels in appendix L to this part.
(6) Unless otherwise indicated in this paragraph, ranges of comparability for estimated annual operating costs are found in the appropriate appendices accompanying this part.
(7) Placement of the labeled product on the scale shall be proportionate to the lowest and highest estimated annual operating costs.
(8) Labels must contain the model's estimated annual energy consumption as determined in accordance with this part and as indicated on the sample labels in appendix L.
(9) The label shall contain the text and graphics illustrated in the sample labels in appendix L, including the statement:

Compare ONLY to other labels with yellow numbers.

Labels with yellow numbers are based on the same test procedures.

(10) Labels must contain a statement as illustrated in the prototype labels in appendix L and specified as follows (fill in the blanks with the appropriate capacity and energy cost figures):

Your costs will depend on your utility rates and use.

Cost range based only on [compact/standard] capacity models.

Estimated energy cost is based on six wash loads a week and a national average electricity cost of ____ cents per kWh and natural gas cost of $ ____ per therm.

ftc.gov/energy.

(11) The following statement shall appear on each label as illustrated in the prototype and sample labels in appendix L:

Federal law prohibits removal of this label before consumer purchase.

(b) Additional information. No marks or information other than that specified in this part shall appear on or directly adjoining this label except that:
(1) A part or publication number identification may be included on this label, as desired by the manufacturer. If a manufacturer elects to use a part or publication number, it must appear in the lower right-hand corner of the label and be set in 12-point type or smaller.
(2) The energy use disclosure labels required by the governments of Canada or Mexico may appear directly adjoining this label, as desired by the manufacturer.
(3) The manufacturer or private labeler may include the ENERGY STAR logo on the bottom right corner of the label for certified products. The logo must be 1 inch by 1 inch in size. Only manufacturers that have signed a Memorandum of Understanding with the Department of Energy or the Environmental Protection Agency may add the ENERGY STAR logo to labels on certified covered products; such manufacturers may add the ENERGY STAR logo to labels only on those covered products that are contemplated by the Memorandum of Understanding.

16 C.F.R. §305.15

72 FR 49971, 8/29/2007, as amended at 73 FR 63068, 10/23/2008; 75 FR 41714, 7/19/2010; 76 FR 20236, 4/12/2011; 78 FR 2209, 1/10/2013; 80 FR 67299, 11/2/2015; 83 FR 14583, 4/5/2018; 84 FR 58034, 11/29/2019